Losi LOS05001 Instruction Manual Page 30

  • Download
  • Add to my manuals
  • Print
  • Page
    / 86
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 29
STARTING PROCEDURE: HOT ENGINE // STARTVORGANG BEI HEISSEN MOTOR //
PROCESSUS DE DÉMARRAGE: MOTEUR CHAUD // PROCEDURA DI AVVIAMENTO:
MOTORE CALDO
1
1. Set the choke lever as shown in Step 1 (choke off).
2. Pull the starter cord in a quick continuous motion to start
the engine. The engine should start within 6 pulls.
1. Placez le levier du starter dans la position de la fi gure 1.
2. Actionnez le lanceur pour démarrer le moteur. Le moteur
devrait démarrer en moins de 6 coups de lanceurs.
1. Stellen Sie den Choke wie in Schritt 1 dargestellt ein.
2. Ziehen Sie den Starter zügig. Der Motor sollte innerhalb
von 6 Zügen anspringen.
1. Posizionare la leva dello starter come illustrato al punto 1.
2. Tirare la corda dell'avviatore con un movimento veloce
e continuo fi nché il motore non si avvia. Il motore
dovrebbe avviarsi entro 6 tentativi.
BREAKING IN THE ENGINE // EINLAUFEN LASSEN DES MOTORS // RODAGE DU
MOTEUR // RODAGGIO DEL MOTORE
Break in the engine by driving
slowly for the fi rst half tank of fuel
(about 25 minutes).
Fahren Sie mit der Hälfte der ersten
Tankfüllung (ca. 25 Minuten) langsam
den Motor ein.
Pour effectuer le rodage, roulez
doucement durant la première moitié
du réservoir. (environ 25 minutes).
Rodare il motore guidando lentamente
per il primo mezzo serbatoio (circa
25 minuti).
NOTICE: Do not adjust carburetor settings during break-in. Doing so will cause engine damage.
HINWEIS: Nehmen Sie während des Einlaufen lassen des Motor keine Veränderungen an den Vergasereinstellungen vor.
Dieses könnte den Motor beschädigen.
REMARQUE: Ne changez pas les réglages du carburateur durant le rodage.
AVVISO: Non toccare le regolazioni del carburatore durante il rodaggio; si potrebbe danneggiare il motore.
2
30
DESERT BUGGY XL • INSTRUCTION MANUAL
Page view 29
1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 85 86

Comments to this Manuals

No comments