Losi LOSB0208BD User Manual download pdf (Page 7)

Resetting and adjusting the

MSC-18BL ESC

FEATURES

1. Auto Detects Brushed or Brushless motor (See Select

Motor Type)

2. One-Touch Endpoints calibration

3. Battery Selection:

a. LiPo (ESC auto detects number of cell:

1S to 3S)

b. NiMH

4. 2 ESC prole:

a. Forward / Reverse with Smart Brake II

b. Forward Only

5. Battery Over Voltage Protection (Max Input voltage =

13V)

6. Thermal Protection

7. Motor Stall Detection

Speed Control Programming

Select Motor Type

When ESC is turned on, it will check the connection

between Red and White wire. If the wires are shorted,

then it will go into brushed motor mode.

Brushed Motor

a. Motor (+) connected to Red and White Wire of ESC

b. Motor (-) connected to Black Wire of ESC

Brushless Motor

Connect the 3 motor wires to Red, White and Black wire of

ESC.

Battery Type Programming

C. LED indicator

After power is turned on, the LED will display the selected

Battery Type for 2 seconds.

Red and Green LEDs are used to display selected Battery

Type:

Red LED Flashing = LiPo is selected

Green LED Flashing = NiMH is selected

To change from one battery type to another (colors described

above), press the setup button during the rst 2 seconds

after turning on ESC. Cutoff voltage will automatically adjust

based on battery type:

For LiPo battery: ESC will auto detect whether it is 1 cell

(3.3V), 2 cell (6V) or 3 cell (9V)

For NiMH: ESC will cutoff at 4.3V

2. LED display during “Normal Operation”

Condition

Stop

Partial Forward

Max Forward

Partial Reverse

Max Reverse

Brake

LED

Green

Off

Red

Off

Red

Red & Green

3. One-Touch Endpoints Calibration Programming:

a. Turn on Transmitter, Throttle in neutral position

b. Hold the ESC setup button and turn on ESC

c. Red and Green LED will turn on, release setup

button

d. Green LED will begin ashing, pull trigger to full

throttle position until Green light turns solid, then

return to neutral position

e. Red LED will ash at this time

f. Push trigger to at maximum reverse position until

Red LED turns solid

g. Release trigger to neutral position and programming

is complete

4. LED display for “Error”

a. Battery Voltage too high (over 13V)---Solid Red LED

and Green LED ashing slowly (Only during Power

ON)

b. Overheat---Alternatively Flashing Red and Green

c. Motor Failure, e.g., wire broken, bad motor, or

jam---Red LED ashing quickly 3 times (repeating

sequence)

d. Battery Low---Green LED solid on and Red LED

ashing slowly

C. Technical Specication:

1. Sensorless Brushless ESC

2. Resistance per phrase: 0.0036 ohm

3. Up to 25A continuous current, 250A surge current

4. Max RPM: 120,000

5. 4 to 7 cells NiMH, or 1, 2 or 3 cell Li Polymer

6. BEC: 6V, 1A

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Comments to this Manuals

No comments

Losi LOSB0208BD User Manual Page 7

Comments to this Manuals

Related products and manuals for Toys Losi LOSB0208BD